Peugeot405
1. The maintenance instruction
2. Maintenance service
3. Engines
4. Fuel system
    4.1. Fuel system with the carburettor
    4.2. One-dot systems of injection of fuel
    4.3. Multidot systems of injection of fuel
      4.3.1. The air filter
      4.3.2. An accelerator cable
      4.3.3. Systems of injection of fuel
      4.3.4. Check and adjustment of systems of injection of fuel
      4.3.5. The case throttle заслонки
      4.3.6. Elements of system of injection Bosch L3. 1-Jetronic
      4.3.7. Elements of system of injection Bosch LU2-Jetronic
      4.3.8. Elements of system of injection Bosch Motronic
      4.3.9. Elements of system of injection Magnetti Marelli
      4.3.10. An inlet collector
      4.3.11. System of giving of air ACAV (models with 16 valves)
5. Systems of greasing, cooling
6. Release system
7. Coupling
8. Transmissions
9. Power shafts
10. A steering
11. Suspension brackets
12. Brake system
13. A body
14. An electric equipment


4.3.8. Elements of system of injection Bosch Motronic FUEL HIGHWAY AND ATOMIZERS

PERFORMANCE ORDER
1. To remove a wire of weight from the accumulator.
2. To remove pressure in fuel system.
3. To lift the receiver the gauge on a regulator of pressure and to unscrew a bolt of fastening of a regulator.
4. To remove electric sockets from atomizers.
5. To unscrew hoses of giving of fuel.
6. To unscrew four bolts from a fuel highway and, lifting upwards, to remove a highway.
7. To remove brackets fastenings of atomizers to a highway and to take them.
8. To check up a condition of ring consolidations and if necessary to replace them.
9. To clear tips of atomizers, applying clearing liquid.

POTENTIOMETER OF POSITION THROTTLE ЗАСЛОНКИ

PERFORMANCE ORDER
1. To remove a wire of weight from the accumulator.
2. To weaken bracket and to remove a socket from a potentiometer.
3. To unscrew two screws and to remove a potentiometer from an axis throttle заслонки.

THE AUXILIARY PNEUMOVALVE OF SPEED OF IDLING

The auxiliary pneumovalve is established from an underside of an inlet collector.

PERFORMANCE ORDER
1. To remove a wire of weight from the accumulator.
2. To weaken bracket and to remove a socket from the pneumovalve.
3. To remove vacuum hoses from the auxiliary pneumovalve.
4. To take the valve from the rubber holder, having extended it aside.

THE GAUGE OF ABSOLUTE PRESSURE IN THE COLLECTOR

The gauge is located on the right party of a motor compartment.

PERFORMANCE ORDER
1. To remove a wire of weight from the accumulator.
2. To unscrew a nut and to remove the gauge.
3. To remove an electric socket and a vacuum hose.

THE GAUGE OF TEMPERATURE OF ARRIVING AIR

The gauge of temperature of air is screwed up in a cover of the air filter.

PERFORMANCE ORDER
1. To remove a wire of weight from the accumulator.
2. To remove an electric socket.
3. To unscrew the gauge and to remove it.

THE GAUGE OF POSITION OF THE CRANKED SHAFT

The gauge of a cranked shaft is located on a face sheet картера transmissions.

PERFORMANCE ORDER
1. To remove a wire of weight from the accumulator.
2. To track electroconducting from the gauge to an electroconducting connector, and to disconnect it from the main plait.
3. To unscrew a bolt of fastening and by means of the lever to take the gauge from a rubber condensing ring.