14.23. Elements of a pillow of safety

THE GENERAL DATA

Gauges of a pillow of safety compound with the electronic control device which is independently compound with a steering wheel. A lamp of the alarm system of a pillow of safety compound with unit of a pillow of safety.

THE ELECTRONIC CONTROL DEVICE OF THE PILLOW OF SAFETY

The electronic control device of a pillow of safety compound with a steering wheel also can be removed only with a steering wheel.

SAFETY PILLOW

Safety pillow – a steering wheel integral part.

Removal

PERFORMANCE ORDER

1. Before performance of any actions on safety system to remove the negative plug from the accumulator and to wait, at least, 10 minutes. 2. To unscrew two screws (are specified by arrows) fastenings of a pillow the safety located from a back part of a steering wheel. For access to screws to turn a steering wheel. 3. To disconnect an electric socket from a safety pillow.

Installation

PERFORMANCE ORDER

1. Installation is made in sequence, return to removal. Thus it is necessary to consider following moments. 2. Not to strike a pillow of safety or to subject to collisions in the course of installation on a former place. 3. To tighten screws of fastening of a pillow of safety the demanded moment. 4. In end to make active system of a pillow of safety for what to execute following actions. 5. To close car doors, thus in the car there should not be people. 6. To include ignition. 7. To connect a weight wire to the accumulator. 8. To switch off ignition. 9. Repeatedly to include ignition and to check up that the lamp of the alarm system of a pillow of safety on a steering wheel burns three seconds then dies away. 10. To include ignition.

ROTARY CONNECTOR OF THE PILLOW OF SAFETY

Rotary connector of a pillow of safety

1 – a rotary connector, 2 – an electric socket, 3 – brackets fastenings of a rotary connector

Removal

PERFORMANCE ORDER

1. To remove a safety pillow. 2. To remove a steering wheel. 3. To unscrew screws of fastening and to remove the bottom casing of a steering column. 4. To remove the top casing of a steering column. 5. To disconnect an electric socket from a rotary connector. 6. Using a screw-driver, to release three brackets fastenings and to remove a rotary connector.

Installation

PERFORMANCE ORDER

1. Installation is made in sequence, return to removal. Thus it is necessary to consider following moments. 2. Before installation on a former place of casings of a steering column and a safety pillow to check up, that the plait of wires has been laid correctly and, moving a steering wheel that electroconducting for what does not cling. 3. To establish a steering wheel. 4. To establish a safety pillow, but not to make active a safety pillow at this stage. 5. In end to move a steering column to the lifted position, then to check up, that the backlash between a back part of a steering wheel and casings of a steering column was 8,0 mm. If the backlash differs from demanded, to execute following actions. 6. To turn away a carpet covering about pedals for access to a coupling bolt of a steering column. 7. To weaken a coupling bolt and to move a steering shaft before backlash reception between a back part of a steering wheel and casings of a steering column equal 8,0 mm. 8. To tighten a coupling bolt and to establish into place a carpet covering. 9. To make active a safety pillow.