7.3. Adjustment of knot of management by coupling

THE GENERAL DATA

Adjustment of knot of management by coupling to check up, measuring a course of a pedal of coupling. If the new cable of coupling is established, to press a coupling pedal, at least, 20 times.

PERFORMANCE ORDER

1. To press a pedal of coupling to a floor and to measure distance from the centre of a platform of a pedal of coupling to a floor. To release a pedal, and again to measure distance from a pedal to a floor. 2. To subtract the first measurement from the second therefore the course of a pedal of coupling equal 145 mm will turn out, otherwise it is necessary to make adjustment. 3. The coupling cable is regulated by a nut of a regulator of the transmission located from outside. On some models, access to a counternut is limited and if it is required, it is necessary to lift the receiver air givings in the engine or the case of the air filter. 4. If the course of a pedal of coupling does not make 145 mm it is necessary to release a counternut (1) and by means of a regulating nut (2) to establish corresponding value. After adjustment repeatedly to measure a course of a pedal of coupling. To repeat this procedure while the course of a pedal of coupling will not reach the demanded size. 5. To tighten a counternut of a cable of coupling and to establish earlier removed elements. 6. C the middle 1994 adjustment of a course of a pedal of coupling is made automatically.