Peugeot405
1. The maintenance instruction
2. Maintenance service
3. Engines
4. Fuel system
5. Systems of greasing, cooling
6. Release system
7. Coupling
8. Transmissions
9. Power shafts
10. A steering
11. Suspension brackets
12. Brake system
13. A body
   13.1. Care of a body
   13.2. Care of an upholstery and rugs
   13.3. Repair of insignificant damages of a body
   13.4. Repair of strong damages of a body
   13.5. A forward bumper
   13.6. A back bumper
   13.7. Replacement of a headlight and the index of turns
   13.8. Replacement of a back lantern
   13.9. Replacement of a forward wing
   13.10. A cowl
   13.11. A cable of the lock of a cowl
   13.12. The cowl lock
   13.13. Replacement of the forward panel
   13.14. Doors
   13.15. A door upholstery
   13.16. The lock and handles of opening of a door
   13.17. Glasses of doors
   13.18. A luggage carrier cover (models the Sedan)
   13.19. The lock of a cover of a luggage carrier (model the Sedan)
   13.20. A back door (model of Kombi)
   13.21. The lock of a back door (model of Kombi)
   13.22. The central blocking
   13.23. Electric window raiser
   13.24. External rear-view mirrors
   13.25. Front and back has flown down
   13.26. The hatch
   13.27. Demountable elements of a body
   13.28. Seats
   13.29. Seat belts
   13.30. Salon furnish
   13.31. A ceiling upholstery
   13.32. The central console
   13.33. The panel of devices
14. An electric equipment


13.26. The hatch
THE GENERAL DATA

Because of complexity of the mechanism of a drive of the hatch considerable experience and knowledge is necessary to restore, replace or adjust hatch elements. For access to hatch elements removal of an upholstery of a ceiling that is very difficult operation is necessary. Therefore THAT is necessary to make this work at station.

THE ENGINE OF THE DRIVE OF THE HATCH

Removal

PERFORMANCE ORDER
1. To remove a negative wire from the accumulator.
2. To remove the switch of light and a plafond of a lamp from the panel of a ceiling for access to screws of fastening of the panel.
3. To remove sun-protection peaks.
4. To unscrew screws and to remove the panel from a ceiling. To disconnect an electric socket from a back part of the panel.
5. To unscrew a bolt of fastening of the tyre of grounding.
6. To remove a suspension bracket of the relay from a ceiling.
7. To unscrew three screws (are specified by arrows) and to remove motor assemblage from a ceiling.

Installation

Installation is made in sequence, return to removal.