Peugeot405
1. The maintenance instruction
2. Maintenance service
3. Engines
4. Fuel system
5. Systems of greasing, cooling
6. Release system
7. Coupling
8. Transmissions
9. Power shafts
10. A steering
11. Suspension brackets
    11.1. A forward suspension bracket
    11.2. A back suspension bracket
      11.2.1. A technical characteristics
      11.2.2. Shock-absorber replacement
      11.2.3. Replacement torsionов
      11.2.4. The stabilizer
      11.2.5. The suspension bracket lever
      11.2.6. Removal and installation of a back suspension bracket
      11.2.7. Adjustment of height of a suspension bracket of a body
      11.2.8. Naves of back wheels
      11.2.9. Features of a back suspension bracket of cars 4 х 4
      11.2.10. Tank replacement
      11.2.11. Removal and installation of the lever of a suspension bracket
      11.2.12. Removal and installation of the cylinder of a suspension bracket
      11.2.13. Removal of air from a hydraulic contour
      11.2.14. Removal and pump installation
      11.2.15. Removal and nave installation
12. Brake system
13. A body
14. An electric equipment


11.2.5. The suspension bracket lever Removal

PERFORMANCE ORDER
1. To lift a back part of the car and to remove wheels.
2. To remove from the corresponding party the shock-absorber.
3. To remove the stabilizer and torsion.
4. To disconnect the brake pipeline on скобе fastenings with the brake pipeline.
5. On a connector of cables to weaken a cable of a manual brake and to disconnect a forward cable from the back.
6. To take a back cable from passes to holders of a beam of a back suspension bracket.
7. To remove the lever.
8. In case of replacement of the lever by the new it is necessary to drill a small aperture in a cover of an axis of the lever of a suspension bracket.

Installation

PERFORMANCE ORDER
1. To check up a condition of the lever, bearings, sealing rings and a surface of connection of the lever and a cross-beam.
2. To establish the lever on an axis.
3. To connect a cable of a manual brake.
4. To connect the brake pipeline.
5. To establish torsionы and the stabilizer.
6. To remove air from brake system.
7. To establish wheels and to put the car on them.